3d printed Flashlight Scope Clamp / Mount
|
Drew up a little flashlight scope clamp to mount my red flashlight to scope for hunting coyotes. Both diameters of the clamp are set up for a 1″ tube. A 1/4 x 20 bolt is used to join the pieces and I added a cap to the bolt to allow adjustment without tools. The one side is recessed to house the 1/4 x 20 nut. I may build up the bolt side so a spacer is not needed with the cap but this works for now. I printed with supports but you probably don’t need them. Printed on a XYZprinting Da Vinci 1.0 3D Printer
This flashlight scope clears my 40mm objective but I haven’t tried it on the 50mm. I may have to make the entire assembly longer if it is an issue. Originally posted on thingiverse here: http://www.thingiverse.com/thing:620622